50E and using switchports independantly

[daffoml]

I'm not sure I'm asking it correctly, but what I have is 3 VLANS setup, besides the built in lan interface.

What I'd like to do is have is LAN 1 set as as untagged in VLAN 1, LAN 2 untagged in VLAN 2, LAN 3 untagged in VLAN 3, and LAN 4 untagged in VLAN 4, LAN 5 has VLAN1 untagged, and VLANS 2, 3, and 4 tagged.

I have the last part working, where VLAN1 is untagged, and the other 3 are tagged.  I have removed ports 2,3, and 4 from the LAN interface, but now I don't how to make them "dumb" layer 2 ports.

I tried going into the CLI and using the following:

config sys interface

edit "vlan3"

set interface "lan4"

end

The result was:

VLAN IP or physical interface cannot be changed once a VLAN has been created.

So, do I need to wipe it, and start over?

Thanks!

[ede_pfau]

Yes, VLAN definitions are not editable. Either you have to remove all references to that (virtual) port (e.g. VLAN2), delete and recreate the VLAN, or get a config backup file, edit and restore (with reboot).

[Toshi_Esumi]

And, I'm hoping someone would scold me "You're wrong!", but I don't think any FG supports "untagged" vlan access port.