Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
markpartin2000
New Contributor

Policy Installation Fails On wireless-controller settings

Good day. I'm relatively new to FortiGate and trying to configure my first HA setup using FortiManager. When I try to install policy, it fails with the below log related to the wireless configuration. (edit: we are not using wireless on these units) I have tried manually modifying the config via SSH, which cleared up several other reported issues, but I can't get this one to resolve. 

 

Please advise how I might resolve the wireless-controller errors so that I can get FortiManager to successfully update policy.

 

Thanks in advance.

 

 

Starting log (Run on device)

Start installing firewall01 $ config wireless-controller wtp-profile firewall01 (wtp-profile) $ edit "FAPU431F-default" firewall01 (FAPU431F-default) $ config radio-2 firewall01 (radio-2) $ unset band firewall01 (radio-2) $ end firewall01 (FAPU431F-default) $ next firewall01 (wtp-profile) $ end firewall01 $ config wireless-controller wtp-profile firewall01 (wtp-profile) $ edit "FAPU433F-default" firewall01 (FAPU433F-default) $ config radio-2 firewall01 (radio-2) $ unset band firewall01 (radio-2) $ end firewall01 (FAPU433F-default) $ next firewall01 (wtp-profile) $ end

---> generating verification report (vdom root: wireless-controller wtp-profile "FAPU431F-default" radio-2:band) remote original: <unset> to be installed:

(vdom root: wireless-controller wtp-profile "FAPU433F-default" radio-2:band) remote original: <unset> to be installed:

<--- done generating verification report

 

------- Start to retry --------

firewall01 $ config wireless-controller wtp-profile firewall01 (wtp-profile) $ edit "FAPU431F-default" firewall01 (FAPU431F-default) $ config radio-2 firewall01 (radio-2) $ unset band firewall01 (radio-2) $ end firewall01 (FAPU431F-default) $ next firewall01 (wtp-profile) $ end firewall01 $ config wireless-controller wtp-profile firewall01 (wtp-profile) $ edit "FAPU433F-default" firewall01 (FAPU433F-default) $ config radio-2 firewall01 (radio-2) $ unset band firewall01 (radio-2) $ end firewall01 (FAPU433F-default) $ next firewall01 (wtp-profile) $ end

---> generating verification report (vdom root: wireless-controller wtp-profile "FAPU431F-default" radio-2:band) remote original: <unset> to be installed:

(vdom root: wireless-controller wtp-profile "FAPU433F-default" radio-2:band) remote original: <unset> to be installed:

<--- done generating verification report

install failed

0 REPLIES 0
Announcements

Select Forum Responses to become Knowledge Articles!

Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.

Labels
Top Kudoed Authors