Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
New Contributor

Multiple MPLS into switch

Hi All,


If I will terminate different MPLS or Point to point links into the Layer 2 or 3 switch and connect the firewall with a Single wire to Switch, can I am able to configure multiple MPLS into one link or Do I need to terminate the MPLS link into the Firewall port

Esteemed Contributor III

I would terminated them at access ports with different VLAN and connect the FGT on a trunk port at the switch. Then configure two VLAN interfaces on the same port of the FGT.



New Contributor

Thanks, Does BGP routing supported in Sub Interface as I need to configure a new MPLS config in Sub Interface and Route the traffic to LAN Subnet and where LAN Subnet already routed to different connected MPLS interfaces? how Hosts behind LAN Subnet to reach Sub interface

Top Kudoed Authors