Hi!
On one hand, Fortinet warns "Packet capture can be very resource intensive. To minimize the performance impact .. use packet capture only during periods of minimal traffic ... and be sure to stop the command when you are finished." But, on the other hand, (in 7.0) FortiOS allows almost indefinite execution (only limited by maximum packet count which can take indefinite time to meet.)
Using CLI, is it possible to show currently active packet captures on the device (ie. both - those provisioned under "firewall sniffer" or activated using "diagnose sniffer packet")?
Thanks, Feren
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
Every packet capture started in GUI (Network/diagnostic/packet capture) starts a new process "httpssnifferd", so you can see them with:
diag sys process pidof httpsniffer
or
fnsysctl ps (this will give some more information about the packet filters applied)
But this doesn't apply for applet capture or SSH capture. I couldn't find a way to see the active capture processes in these cases. That should be within the SSH/console connection process. It may be helpful to see which admin sessions are active and disconnect them if needed: Technical Tip : List active admin session of Firewall and disconnect the session via Command Line
Hi @AlexC-FTNT
Every packet capture started in GUI (Network/diagnostic/packet capture) starts a new process "httpssnifferd", so you can see them with:
diag sys process pidof httpsniffer
or
fnsysctl ps (this will give some more information about the packet filters applied)
I'm not seeing "httpssnifferd" or "httpsnifferd", but I am seeing "raw_snifferd". Can you clarify?
Thanks!
I have no information at all on "raw_snifferd". Probably a matter of naming in different FortiOS versions.
Hello Feren,
If you're using the packet capture tool in the GUI, you can control it via the CLI using the `on-demand-sniffer` commands, which are available in FortiOS version 7.4.4 and above.
To list all packet captures, use the following command:
# diagnose on-demand-sniffer list
However, please note that there are no options to list currently active packet captures; running with a terminal program like PuTTY or the CLI console from the GUI.
Using the packet capture tool [https://docs.fortinet.com/document/fortigate/7.4.4/administration-guide/462154/using-the-packet-capt...]
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1547 | |
1030 | |
749 | |
443 | |
210 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.