I have been having an issue with high memory usage on my 100D's since upgrading to 5.4.
I have done a factory reset and clean imaging of the 100D's.
I did have local logging turned on, but shut that off last night. memory was still building from 40% last night to 53% this morning.
I did switch the master and slave last night.
I disconnected HA this morning, wondering if the slave 100D is having the issue and flooding the memory on the master. Since doing this memory dropped back to 48% and is holding for the moment, but time will tell.
Hoping someone on here can shed a little light on the subject. What exactly uses memory and why it does not seem to be cleaning it up as needed.
Thanks
Brian
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1735 | |
1107 | |
752 | |
447 | |
240 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.