Description This article explains the mac address behavior when the
source server from the primary IP network reaches to destination server
on a secondary IP network. Scope FortiGate. Solution FortiGate's
physical interface has 2 IP networks: Primary...
Description This article describes the scenario for VIP port forwarding
in an NGFW policy-based central NAT setup. Scope FortiGate Central NAT.
Solution In the scenario of 2 DNATs are configured. One DNAT with port
forwarding but the other DNAT witho...
Description This article describes that 'show in address list' option is
not available for firewall addresses and address groups. Scope FortiOS
v6.4 and above. Solution For version 6.2, the option 'show in address
list' is available as below: From GU...
Description This article describes the issue when FortiGate Cloud Report
shows 'Internal Server Error'. Scope FortiGate Cloud Report Solution
When trying to load the FortiGate Cloud Report page and getting
'Internal Server Error': Run debug: # diagno...
Description This article describe the method to generate log test from
FortiGate. The log test is useful to verify the logging status.
Customize log test detail could allow the user to generate the
description for log identification. Scope FortiGate ...
Hi Acxelsus, What is firewall firmware version? You may try to run
httpsd debug to check the LDAPS negotiation or you may try disable
server-identity-check config user ldapedit xxx>>> Server Nameset
server-identity-check disableend For httpsd debug: ...
Hi Acxelsus, You may verify the connection to LDAP server with the
following command: # diagnose sniffer packet any "host x.x.x.x and port
yy" 4 Replace x.x.x.x to the LDAP server IP and yy to the LDAP port . -
verify the outbound interface - verify ...