In short: Is there an AI assisted way to upgrade FortiOS, comparing
current configurations with releasenotes? When upgrading a system with
several releases between the current and destination versions, the
traditional approach involves:Collecting Rel...
I just wonder how one would or could implement a WAF URL filter (?) with
Fortigate board utilities for Let's Encrypt renewals? That is, how would
a policy have be setup to allow Let's Encrypt to access an internal
webserver to get the renewal token a...
I need to install a few FortiSwitches (FS) as replacement for very old
cisco switches in a quite remote site.I already got the switches here in
my office and wanted to prepare them before I go onsite. How should or
could I prepare the FortiSwitches h...
Might be a simple one for you. Any hint is appreciated.I have a FGT-60F
cluster that has an active LDAP server pointing to an AD server that is
located on a local "internal1" interface. This connection works fine. If
I do "Test Connectivity", I can s...
Using the menu "VPN Location Map" does show me a nice overview of the
currently connected VPN connections (IPSEC, SSL VPN). However, the
locations of the fortigate are most of the time somewhere in the Gulf of
Guniea (0°S, 0°E). The physical location...
Thanks for the detailed explanation @Jeremy5385 , I actually tried
moving with the "Integrate Interface" funktion, but that failed. It said
that the task needs to be done manually. It was not such a complex setup
after all, so I edited the config fil...
@hbac I have a 40F with 7.2.8 in my testlab and made some tests. Created
an interface lan1 with an attached vlan. Then used "Integrate Interface"
to move lan1 to fortilink. I tried it twice. Results:- "Move lan1 to an
interface" (the Integrate Interf...
Thanks @hbac ,I have not been using "Interface migration" so far. But
reading the doc seems to indicate that the destination confguration is
replaced by the moved configuration. Would I have to re-enable fortilink
again on that interface?