Technical Tip: How to enable the visibility of Proxy Mode in Firewall Policies on v7.4.0+

[VinayHM]

Description	This article describes how to enable the visibility of Proxy Mode in policies.
Scope	FortiGate v7.4.0 and above.
Solution	By default, all policies will be in flow mode. To allow the policy to be changed to Proxy mode in the GUI, follow these steps: Go to System -> Feature visibility and enable Policy Advanced Options under Additional Features. Run the following configuration: config system settings     set gui-proxy-inspection enable end Note: If the inspection mode is still not visible in the GUI, try the following steps: Log out and log back into the GUI. Clear the browser cache. As a last resort, restart the HTTPS daemon with the following command: fnsysctl killall httpsd Refresh the web page of the FortiGate GUI. Note:  This solution is only applicable when the FortiGate NGFW is operating in Profile-Based mode. It does not apply to Policy-Based mode configurations. Related documents: Starting from v7.4.4, proxy-related features have been removed from 2GB models:  2 GB RAM FortiGate models no longer support FortiOS proxy-related features Proxy-related features not supported on FortiGate 2 GB RAM models NEW Technical Tip: Cannot enable Explicit Proxy feature in FortiGate 2GB Model