Description This article describes the behavior of FortiGate Threat Feed
External Connector when changes are detected. FortiGate external
connector allows administrators to poll IP addresses or Domains from
external sources for traffic control. The p...
Description This article describes the behavior of FortiPAM Log Disk and
Video Disk when TPM was already enabled and configured at first, and
disabling the configuration at a later stage. Scope FortiPAM. Solution
It is possible to deploy FortiPAM wit...
Description This article describes the troubleshooting steps for a
FortiGate high availability issue after a firmware upgrade. The issue
occurs when the primary FortiGate fails to forward traffic to the
virtual server after becoming the primary unit....
Description This article describes the steps to control subnet
advertising on OSPF links when the redistribute static is enabled. Scope
FortiGate. Solution In certain network requirements, connections between
FortiGates are controlled by OSPF redistr...
Description This article describes how to troubleshoot the issue on
FortiGate-80F, where the interfaces of wan1 and wan2 (fiber connection_
are down after upgrading to v7.4.8). Scope FortiGate-80F v7.4.8.
Solution After upgrading FortiGate-80F to v7....
Hi @FortiNet_Newb You might want to check out the following article to
see if it matches the issue that you are facing:
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Multi-Factor-Authentication-support-for-Windows/ta-p/407272
Hi, You might be using the 15 days evaluation license in Hyper-V which
was now replaced with a permanent evaluation license:
https://docs.fortinet.com/document/fortigate/7.2.9/administration-guide/441460
There is a difference between the license mode...
Hi @nanashi You may want to check your local browser if it is synced
with a NTP server as well. This issue can happen if the FortiGate system
time differs by more than 2 minutes from the local client (browser)
time.
http://community.fortinet.com/t5/F...
Hi @Saidb I believe I could only provide partial information based on
your queries: 1. There are already templates ready to be used for
integrating FortiPAM to third-party devices. 2. Yes, you can manage
RDP/SSH sessions directly through FortiPAM wit...
Hi @SoonerDaddio , How did the clients on your Lab VLAN gets it's IP? If
it's via DHCP, you want to ensure that the VLAN settings have DNS set to
interface IP, but not follow system settings:
https://docs.fortinet.com/document/fortigate/7.6.3/adminis...