Description This article describes an issue where the status of the FSSO
secure connection appears as down due to poor key strength. Scope
FortiGate. Solution The FSSO secure connection is displayed as down. In
the Packet Captures, the FortiGate has ...
Description This article describes details about the 'Disk log has
rolled' log entry. Scope FortiGate. Solution The GUI shows the following
log entry: devid="FG100D3XXXXXX" logid="0100032011" type="event"
subtype="system" level="notice" vd="root" eve...
Description This article describes how to resolve the HA status
'Unknown' error. Scope FortiGate. Solution The GUI is showing the HA
status as 'Unknown':The possible causes of this are as follows: The
Secondary FortiGate is running a different firmwa...
Description This article describes how to block ICMP timestamps and
replies for internal traffic that originates from behind the FortiGate.
Scope FortiGate. Solution This article demonstrates an example of how to
block ICMP timestamps and replies for...
Description This article describes why the status of an EMS connector
shows as down for a downstream device in the security fabric after
upgrading to 7.4.5. Scope FortiOS. Solution The status of the EMS
connector shows as down in the GUI for a downst...
@kamarale The Poll works for the FSSO agent. If you have the FSSO agents
installed then it pools the additional information from the server. If
you cannot install the FSSO agent therefore we can continue adding the
LDAP server from the FortiGate GUI ...
@babarmunir Can you please attach the crash logs.Moreover, please run
the following commands if again it goes into conserve mode before
rebooting the device:get system statusget system performance status
<----- Use this command three times leaving a ...
Please try to change the fortiguard settings to these: config system
fortiguard set fortiguard-anycast disable set protocol udp set port 53
set sdns-server-ip 208.91.112.220 set source-ip end
