Description This article provides the required command to telnet a host
from FortiGate. Scope FortiOS Solution To run a telnet from the
FortiGate CLI, enter the same 'execute' command used in FortiADC,
combined with the destination host IP and the TC...
Description This article describes the command needed to source SNMP
traffic from FortiGate using an internal address routable in the IPsec
VPN tunnel to reach a SNMP server on a remote network. Scope FortiGate.
Solution By default, the FortiGate wil...
Description This article describes how to fix HA out of sync which can
be caused due to the command 'set password-expire' mismatching and admin
credentials do not work on the Secondary unit. Scope FortiGate. Solution
When going to FortiGate -> System...
Description This article describes how to create an automation stitch to
send alert emails for new available firmware events automatically. Scope
FortiOS. Solution Create a new Automation Stitch: Go to Security Fabric
-> Automation, select ‘Create Ne...
Description This article explains how to fix a phase1 issue about 'error
constructing ID payload'. Scope FortiGate. Solution When establishing
IPSEC VPN site to site with a peer device using IKEv2, the below error
can be seen in IKE debugs during the...