current F 90D version is 6.0.9 build0335, this FW works as UTM, wan
primary ip is private and secondary ip is the public routed throughout
the private ip to reach internet, all filters to current public ip (set
as secondary) are enabled to allow only...
Following issue shows a wrong connection to Fortiguard-log server,
password is correct and worked properly with another Fortigate device,
diagnose log is activate but I can't connect to Forticloud: FORTI-40F #
execute fortiguard-log login xxxMAILxxx ...
Community Following issue showed a wrong connection to Fortiguard-log
server, password is correct and worked properly with another Fortigate
device, diagnose log is activate: FORTI-40F # execute fortiguard-log
login xxxMAILxxx xxxPWDxxx2024-03-13 12:...
I've upgrade by gui a 40F Fortigate from 07.4.0 to 07.4.2 and readonly
view is the only access I have by gui. By cli all permissions are
granted, until now according troubleshooting there is no chance to roll
back from 07.4.2 to 07.4.0 by gui or cli,...
Thanks a lot, but, just a doubt, how is considered the priority between
local-in policy and management interface trusted hosts? if the ip is
blocked through local-in policy but allowed inside trusted host ?
Really preciated, I need to allow only some icmp source, i.e. my monitor
network, and closed to everyone else, I cant identify which rule is the
proper one to block
1 and 3. Routing is configured fine, but I can´t reach internet anything
outside vpn,2. Firewall policies are similar to another device without
any issue4. There is no resolution simimar reply than point #15. Time is
set and correct6. Is the last ava...
