Hello community, Is there a way to block MAB for rogue devices in
FortiNAC? The issue i'm facing is with a Cisco Switch with the following
configuration in the portsinterface GigabitEthernet1/0/9switchport
access vlan 31switchport mode accessswitchpo...
Hello Community, Is there a way to create a stitch to perform an action
if an event is preset for an ammount of time?Example:A fortiswitch port
is disconnected...then I can grab that event and create a stitch to
notify vía email when this happens..Bu...
Hi community, Is it possible to create a captive portal in FAC with
users to authenticate with Google SAML? I have tested directly in
FortiGate and it works fine, but what I'm trying to do is to limit the
amount of devices that can connect with a use...
Hi community, Is there a way to monitor Fortiswitches temperature
connected by fortilink to a FortiGate? I have found the following post,
but it's a snmp trap or syslog with no
fortilinkhttps://docs.fortinet.com/document/fortiswitch/7.2.7/administrat...
Hi community! I've been using the FAZ handlers and they've been a great
help. I am trying to exclude the notifications for a specific network,
so according to documentation it has to be inserted with Regex in
Generic
https://docs.fortinet.com/documen...
Thanks @ebilcari, I configured the registration with the isolation VLAN
to achieve this...It would be nice have an option to block MAB
authentication for certain MAC address
Hey @Nemesis31 The current hub is internet or MPLS? Does the new hub
would be internet or MPLS?If both are internet and you are configuring
ADVPN, you should not have problems if you are using ADVPN, you can
check this link for
guidancehttps://docs.f...
There is no limitation on FG-100F to send syslog. Have you checked with
a sniffer if the device is trying to send syslog?? You can try diag
sniffer packet any 'port 514' 4 n if you have a different port
configured for sending syslog you can change th...
Hi @DPadula Yes, with SNMP is achievable, the only drawback is that via
SNMP you get all the interfaces status from every single port of the
switch, then you have to make a lot of exclusions to handle that you
want to receive notifications only for s...
yeap, when fortimail "rejects" won't send a DSN (Delivery Status
Notification)...some emails when are blocked, fortimail responds with a
DSN (404, 503...etc, depending on the type of blocking), but when it's
rejected...FortiMail won't send a DSN, to ...
