Hi all, I just want to confirm about the command "diagnose debug
enable".If I enabled "diag debug enable" command in Fortigate it will
only enabled only for 30 min or it will run as long as I don't reset or
manually disable the debug?Also , after I r...
Hi All , We've FortiGate Firewalls running Active-Passive HA. We've
enabled VDOMs and root VDOM is the management VDOM.We have local NTP
server. But FortiGate time is not syncing with local NTP server.
FGT-INR03 (global) # execute timecurrent time is...
Hi All,I've setup HA interface monitoring for FortiGate. When the link
from primary unit down , the Firewall should Failover but it didn't
failover and the primary unit still remain active regardless of the
links fail.I tried removing both FortiGate ...
HI, today we migrated FortiGate 200D to 201F. In 201F , whenever we
tried to restore the configuration , it's showing "Failed to restore
system configuration".But the restoration was successful regardless of
showing the alert and the FortiGate was al...
Hi all,We've FortiGate firewalls running without VDOM.Now we need to
enable VDOM feature but after we enabled the VDOM feature , the current
existing config will be migrated into root VDOM.We don't want the
existing config migrated into root VDOM.We ...
Hello,thank you for your suggestion.Yes, same version, same model, same
FortiGate box backup config file from the same Firewall and then restore
into same firewall , the alert still appear .Also upgraded the firmware
and test again on the same box , ...
We are using the exported config from converter. We even tried export
blank config from 201F itself and restored the 201F blank config to the
unit , still showing the alert even for the same model /same
version.Other than showing the alert , there is...