Re: memory conserve threshold values are hardcoded...

dkochhar · 04-01-2025

Description This article describes an issue where the 'Default_AWS' object configuration gets changed after upgrade. Scope FortiGate. Solution This happened after upgrading to v7.0.17 from any FortiOS version.Run the following command to encounter th...

dkochhar · 04-01-2025

Description This article describes how to resolve the 'Access Denied' error while creating an Antivirus profile. Scope FortiGate. Solution The GUI shows the following error while attempting to change the antivirus profile. This issue occurs in the GU...

dkochhar · 03-19-2025

Description This article describes an issue where the status of the FSSO secure connection appears as down due to poor key strength. Scope FortiGate. Solution The FSSO secure connection is displayed as down. In the Packet Captures, the FortiGate has ...

dkochhar · 03-18-2025

Description This article describes details about the 'Disk log has rolled' log entry. Scope FortiGate. Solution The GUI shows the following log entry: devid="FG100D3XXXXXX" logid="0100032011" type="event" subtype="system" level="notice" vd="root" eve...

dkochhar · 03-02-2025

Description This article describes how to resolve the HA status 'Unknown' error. Scope FortiGate. Solution The GUI is showing the HA status as 'Unknown':The possible causes of this are as follows: The Secondary FortiGate is running a different firmwa...

dkochhar · 11-04-2024

@Knuppel1983 Unfortunately, this is a global feature. This setting is not available per tunnel for now.

dkochhar · 10-30-2024

@kamarale The Poll works for the FSSO agent. If you have the FSSO agents installed then it pools the additional information from the server. If you cannot install the FSSO agent therefore we can continue adding the LDAP server from the FortiGate GUI ...

dkochhar · 10-30-2024

@babarmunir Can you please attach the crash logs.Moreover, please run the following commands if again it goes into conserve mode before rebooting the device:get system statusget system performance status <----- Use this command three times leaving a ...

dkochhar · 10-26-2024

@moverall2 Can you please confirm your Forticlient version ?

dkochhar · 10-26-2024

Please try to change the fortiguard settings to these: config system fortiguard set fortiguard-anycast disable set protocol udp set port 53 set sdns-server-ip 208.91.112.220 set source-ip end

User Statistics

User Activity

Technical Tip: 'Default_AWS' object deleted after upgrade

Troubleshooting Tip: 'Cannot read properties of undefined (reading 'entries')' error while creating Antivirus profile

Troubleshooting Tip: FSSO status down due to poor key strength

Troubleshooting Tip: Getting 'Disk log has rolled' message in logs

Troubleshooting Tip: HA status 'Unknown'

Re: IPsec TCP port per tunnel

Re: Fortigate - Explicit proxy with Kerberos