Description This article describes an issue where the 'Default_AWS'
object configuration gets changed after upgrade. Scope FortiGate.
Solution This happened after upgrading to v7.0.17 from any FortiOS
version.Run the following command to encounter th...
Description This article describes how to resolve the 'Access Denied'
error while creating an Antivirus profile. Scope FortiGate. Solution The
GUI shows the following error while attempting to change the antivirus
profile. This issue occurs in the GU...
Description This article describes an issue where the status of the FSSO
secure connection appears as down due to poor key strength. Scope
FortiGate. Solution The FSSO secure connection is displayed as down. In
the Packet Captures, the FortiGate has ...
Description This article describes details about the 'Disk log has
rolled' log entry. Scope FortiGate. Solution The GUI shows the following
log entry: devid="FG100D3XXXXXX" logid="0100032011" type="event"
subtype="system" level="notice" vd="root" eve...
Description This article describes how to resolve the HA status
'Unknown' error. Scope FortiGate. Solution The GUI is showing the HA
status as 'Unknown':The possible causes of this are as follows: The
Secondary FortiGate is running a different firmwa...
@kamarale The Poll works for the FSSO agent. If you have the FSSO agents
installed then it pools the additional information from the server. If
you cannot install the FSSO agent therefore we can continue adding the
LDAP server from the FortiGate GUI ...
@babarmunir Can you please attach the crash logs.Moreover, please run
the following commands if again it goes into conserve mode before
rebooting the device:get system statusget system performance status
<----- Use this command three times leaving a ...
Please try to change the fortiguard settings to these: config system
fortiguard set fortiguard-anycast disable set protocol udp set port 53
set sdns-server-ip 208.91.112.220 set source-ip end
