Re: FortiNAC deployment

salemneaz · 02-04-2024

Description This article describes how to compare FortiGate Firewall Configuration using Notepad++. Scope FortiGate, Notepad++ Solution Comparison of configuration backups is required when sometimes, some of the features are not working as expected a...

salemneaz · 01-22-2024

Description This article describes how to make use of an NTP Server that is not connected with the default management VDOM which is root VDOM. Scope From v6.4 and above. Solution The NTP is located on the internet and can be reached from the root VDO...

salemneaz · 11-19-2023

Description This article demonstrates how to access a local host from an SSL VPN and vice versa. Scope All supported versions of FortiOS. Solution After connecting to the SSL VPN, the usual process is to connect to the resources located in the inside...

salemneaz · 08-27-2023

Description This article provides an example of how to enable Voice VLAN on FortiSwitch which is managed by FortiGate. Scope FortiGate. Solution The IP Phones require an IP address from the Voice VLAN block, and this requirement applies to the scenar...

salemneaz · 12-27-2022

Description This article describes how to set Source IP for SYSLOG in HA Cluster. Scope FortiGate. Solution At the '# config system ha' under the global VDOM, it is necessary to check if HA direct enable is enabled or not. If HA direct is enabled, th...

salemneaz · 01-21-2024

Hi, You can follow this article reference given below, this will assist you to configure SDWAN without FortiManager, although this is for Firmware Version 7.4 but other versions going down to 7.0 is similar to this article. https://docs.fortinet.com/...

salemneaz · 01-21-2024

Hi Chris, The 200D can take 6.0.17 Firmware, i will not go beyond that, and you can download the firmware from support.fortinet.com site. log into support.fortinet.com --- Support ---- Firmware Download, then select Firmware version 6.0 nevigate insi...

salemneaz · 01-21-2024

Layer 2 (L2) polling - FortiNAC reads the network device's MAC address table. Layer 3 (L3) polling - FortiNAC reads the network device's ARP table. https://community.fortinet.com/t5/FortiNAC/Technical-Tip-Comprehensive-guide-for-a-simple-FortiNAC/ta-...

salemneaz · 01-21-2024

If the UTM profiles are not enabled at the Policy then the logs and report will not be shown, also check if the event logging is enabled at the logs and report settings. https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-configure-loggi...

salemneaz · 01-21-2024

From this error "curl: (6) Could not resolve host: POST" at the first line it looks like it is a DNS issue. The hostname cannot be resolved. And the second error message is related to the authorization check the output "Either you supplied the wrongc...

User Statistics

User Activity

Technical Tip: Compare FortiGate Firewall Configuration using Notepad++

Technical Tip: Access NTP Server Connected directly with Non-Management VDOM

Technical Tip: Access a particular IP block from SSL VPN

Technical Tip: Configure Voice VLAN on FortiSwitch

Technical Tip: Set Source IP for SYSLOG in HA Cluster in VDOM environment

Re: Here is how to configure Sdwan without the Fortimanager

Re: Firmware download