Description This article describes how to compare FortiGate Firewall
Configuration using Notepad++. Scope FortiGate, Notepad++ Solution
Comparison of configuration backups is required when sometimes, some of
the features are not working as expected a...
Description This article describes how to make use of an NTP Server that
is not connected with the default management VDOM which is root VDOM.
Scope From v6.4 and above. Solution The NTP is located on the internet
and can be reached from the root VDO...
Description This article demonstrates how to access a local host from an
SSL VPN and vice versa. Scope All supported versions of FortiOS.
Solution After connecting to the SSL VPN, the usual process is to
connect to the resources located in the inside...
Description This article provides an example of how to enable Voice VLAN
on FortiSwitch which is managed by FortiGate. Scope FortiGate. Solution
The IP Phones require an IP address from the Voice VLAN block, and this
requirement applies to the scenar...
Description This article describes how to set Source IP for SYSLOG in HA
Cluster. Scope FortiGate. Solution At the '# config system ha' under the
global VDOM, it is necessary to check if HA direct enable is enabled or
not. If HA direct is enabled, th...
Hi, You can follow this article reference given below, this will assist
you to configure SDWAN without FortiManager, although this is for
Firmware Version 7.4 but other versions going down to 7.0 is similar to
this article.
https://docs.fortinet.com/...
Hi Chris, The 200D can take 6.0.17 Firmware, i will not go beyond that,
and you can download the firmware from support.fortinet.com site. log
into support.fortinet.com --- Support ---- Firmware Download, then
select Firmware version 6.0 nevigate insi...
If the UTM profiles are not enabled at the Policy then the logs and
report will not be shown, also check if the event logging is enabled at
the logs and report settings.
https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-configure-loggi...
From this error "curl: (6) Could not resolve host: POST" at the first
line it looks like it is a DNS issue. The hostname cannot be resolved.
And the second error message is related to the authorization check the
output "Either you supplied the wrongc...