Hello Guys,I have two questions about the Ike V2 IPSEC DIalup
Connection. I want to configure in my enviroment (two fortigate 100F HA)
like 150 dialup external connection. I have setup an IPSEC Tunnel
(IkeV2) and set policy correctly. I created the u...
Hi at all,I create a VPN IPSEC for FortiClient:And this is the client
configuration:But the connection fail every time I have enabled the
debug log:ike 0: comes
ClientIP:1011->FortiGateIPWAN:500,ifindex=8,vrf=0....ike 0: IKEv1
exchange=Aggressive id=...
Hello Community, i'm new to the world of FortiSwitch (i had configure a
lot of FortiGate) but i'm in trouble with the switch. So, we have for a
customer a FortiSwitch that i must configure.The customer have one
switch L3 (Aruba, not FortiSwitch) with...
After i seen this post, i remove the group from FIrewall Policy and keep
only the group in phase1 and the fgtauth page disappear....thank you so
much again to all!
Hi Yuri, is correctly. The users can authenticate with the FortiClient,
and when search a internal LAN IP (like a NAS) appears the redirect fgt
auth portal. But in all the settings (Interface, Users, ecc...) the
captive portal is set to off.
I appreciate it if someone can explain this.I don't understand why, if i
put this:config vpn ipsec phase1-interfaceedit "IPSEC_NOVA"set type
dynamicset interface "wan1"set ike-version 2set peertype anyset
net-device disableset mode-cfg enableset prop...
Hi Yuri thanks for your indications, and sorry for bad explanation of
questions!So my problem is, if i set this:set authusrgrp
yurisk1grpEverytime that the people try to reach some internal ip (like
a NAS or other) appear a fgtauth webpage (although ...
