Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
Albimatta
New Contributor II

Configuration of new FortiSwitch Standalone

Hello Community, i'm new to the world of FortiSwitch (i had configure a lot of FortiGate) but i'm in trouble with the switch.

 

So, we have for a customer a FortiSwitch that i must configure.

The customer have one switch L3 (Aruba, not FortiSwitch) with all the ports untagged on VLan 1 default and tagged for all the others Vlan's (Vlan10, Vlan3, Vlan20). The L3 switch have an IP Address on every Vlan's (On VLan10 192.168.0.1, On VLan3 192.168.3.1 and on Vlan20 192.168.20.1), and is direclty connect with ALL the others switch

All the switch's of customer have an IP on 192.168.3.0/24 that is the MGMT VLAN (Vlan3)

So, i want to add in a floor, the FortiSwitch 124F PoE, and i have problems with the configuration:

- I changed the Physical address for 0.0.0.0/0 to 192.168.3.6 (the Ip choice). I left the Vlan ID1 with the default IP 192.168.1.99

- I added a static route 0.0.0.0/0 to 192.168.3.1 (The L3 Switch) 

- I changed the Port 25 SFP with native VLAN ID1 and Allowed all the others VLAN's and i left the internal configuration as it was (VLAN Native 1 and allowed the others VLAN's)

And..nothing to do.

 

I try to left the IP address of Physical interface to 0.0.0.0 and add the VLAN3 under System-Network-Interface adding a seocndary IP address 192.168.3.6 and ID Vlan 3 but nothing to do, i cannot ping the switch. 

 

What i wrong? 

5 REPLIES 5
srajeswaran
Staff
Staff

Can you share the configuration of physical port connecting to "The L3 Switch"  along with the VLAN3 config and route you have added.

Regards,
Suraj
- Have you found a solution? Then give your helper a "Kudos" and mark the solution.
Albimatta

Hello thanks for the answer:

This is the port:

 

Port.png

 

THis is the VLAN3 configuration and the Physical port:

 

VLAN3.png

 

And this is the static route

 

stroute.png

Albimatta
New Contributor II

Edit: Now i have found that the ID under the Secondary IP isn't the VLANID, so i've changed the configuration with this:

 

Secondip.pngLAN.png

 

I removed every Secondary ip, and left only the IP of VLAN3.

Albimatta
New Contributor II

Anyone can help me?

ronaldrenew
New Contributor

Malfunctions in the electrical area of ​​auto air conditioners are often due to improper operation of the device itself. Typically, the root of the defect is pressure sensors, electromagnetic clutch coils, compressor electromagnetic valves, control units, fans, and so on. Each case is individual, it is impossible to say anything without checking on diagnostic equipment and a highly qualified specialist here.

Announcements

Select Forum Responses to become Knowledge Articles!

Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.

Labels
Top Kudoed Authors