Description This article describes the steps to re-build cluster on
FortiWeb Scope FortiWeb all platforms Solution 1. Back up the
configuration from the current Master node. 2. Access the FortiWEB unit
that needs to be added to the cluster, run the c...
Description This article discusses about activating license using the
same license(.lic) file which was used previously would result in error
'Duplicate license has been detected'. Scope Solution Wait for 90
minutes for the license to update. This ma...
DescriptionThis article explains how to enable the debug log within
FortiClient. Solution1. Launch FortiClient.2. Go to File > Settings.3.
Expand “Logging” section and enable relevant features for which debug is
required.4. Set “Log level” as “Debug”...
DescriptionThis article addresses the configuration of a FortiGate unit
as a NTP server.SolutionWhen you configure system time from the System
Information dashboard widget, you can configure the FortiGate unit to be
a NTP server. As part of the NTP s...
DescriptionWhen a Web-filter profile is cloned, the URL filter table of
the parent profile will be reflected in the cloned profile. The URL
table in the cloned profile can be modified by using the Command Line
Interface (CLI).SolutionParent profileCl...
There is a new update for the WAF signatures to prevent attackers from
performing variant remote code execution in Apache Log4j2
For FortiWEB, there is a new update for the WAF signatures to prevent
attackers from performing variant remote code execution in Apache Log4j2
For FortiWEB, a signature has been released to mitigate vulnerability
reported under CVE-2021-44228 in WAF signature database version 0.00305
could verify the version by issuing th...
Hi, If you are enabling the client real IP option in the server policy,
then you need to set FortiWeb as the default gateway on the backend
server. Instead, you could configure FortiWeb to include X‑Forwarded-For
in the HTTP header before traffic is ...
Fortigate can be configured as NTP server. This is applicable with
FortiOS 5.0 and 5.2 as well. CLI configuration syntax-config system
ntpset ntpsyn enableset server-mode enableset interface
end Regards,Deepak G N R