Description This article describes why BGP peer withdrawn prefixes from
the routing table. Scope FortiGate, BGP. Solution If the BGP has a route
missing in the routing table, it is necessary to run the following
commands to collect the logs: diagnose...
Description This article describes that during the authentication,
FortiGate sends duplicate requests for 2FA authentication. Scope
FortiGate v6.0+,v7.0+,v7.2+ and v7.4+. Solution When configuring 2FA
with Radius authentication and encountering two t...
Description This article provides the solution for a stable connection
for the WWAN interface when using the Verizon network in a 3G/4G LTE
modem. Scope FortiGate 3G/4G modem, Verizon network. Solution Anyone
with the same issue must identify no sour...
@rezafathi , Yes that would also work or you can merge vlans to a
particular zone and apply specific source and destination to policy to
pass the traffic. In this way you can reduce multiple interfaces per
policy.
https://docs.fortinet.com/document/f...
Hi @jr14, Yes, you can re-distribute your route using a route map. Here
is the reference document, this would help you
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Redistribute-BGP-routes-learnt-through-different/ta-p/240300
Hi @Max99, Thanks for your input. You can clearly see in the output vd:
root/0name: StS-VPN-dvnetzwversion: 2interface: wan1 6addr: :500 -> :500tun_id: 10.0.0.5/::10.0.0.5 <-----
This is the tunnel ID showing under the static route gateway. This show...
Hi @Rizgiff, This issue usually occurs due to IPv6 being enabled on the
NIC of the client machine. Please refer the following article:
https://community.fortinet.com/t5/FortiGate/Technical-Tip-SSL-VPN-fails-at-98/ta-p/248363
You might need to disable...
Hi @rsteixeira, In this scenario, you might have to open a case with the
TAC so we can troubleshoot the issue to verify why Radius authentication
failed. Thank you. Best Regards, Maulish Shah