Hi, I am trying to authenticate the passive firewall via Radius for
management purposes. I have setup as per "Active-passive with external
and internal Azure load balancer (LB)". Active and passive firewall has
dedicated HA management interface confi...
I have Fortigates in Azure deployed as per below scenario:
Active-passive with external and internal Azure load balancer (LB) Can
session synchronization happen between Fortigates? If YES how? If NO
Why?
Fortigate does not re-evaluate the routing table for connection-less
protocols unless the session is terminated? . ICMP and UDP are
considered connection-less protocols by the Fortigate . This means that
once the initial session is established, Forti...
So, if I understood correctly, even if the Fortigate Firewalls in Azure
deployed in HA (A/P) will share sessions (as seen in the session table
of both firewalls), and there is fail-over between them, then the
session which was established with the Ac...
I tested with an SFTP server to verify session synchronization. It
appears that even though sessions are synchronized, the transfer is
halted during failover. However, it automatically resumes after a few
seconds and continues with the file transfer....
Thanks for your answer ,when I initiated RDP connection from my machine
to one of the server behind Firewall then I can see session on both
Firewalls (A/P). When I check session table for both virtual appliances
(FW) , I can see how RDP session can b...
Fort iClient public IP, which is the end user's public IP, is not
visible in Forti Analyzer traffic logs. Only the private IP is
displayed. Is there a reason for this?