Description This article describes how to add bulk MAC address objects
via a script. Scope FortiGate. Solution A list of MAC addresses is
quintessential. For this article, the following MAC addresses will be
used: 00:1A:2B:3C:4D:5E 1A:2B:3C:4D:5E:6F ...
Description This article highlights the case where after a firmware
upgrade REST API stops working. Scope FortiGate. Solution When using the
REST API login, especially in a Multi-VDOM environment, ideally an
upgrade should not affect anything. There ...
Description This article describes how Shared Media interfaces function
on the FortiGate as well as how to use them properly. These specialty
interfaces are found on a subset of FortiGates models, such as the
FortiGate-80/81F and 90/91G. Scope FortiG...
Description This guide illustrates the common SSL VPN best practices
that should be taken into consideration while configuring the SSL VPN on
the FortiGate to further strengthen the security. Scope FortiGate.
Solution Changing the default port: By de...
Description This article describes how, starting from v7.6.x, a Local-In
policy can be created via the GUI. Scope FortiGate v7.6.x. Solution In
previous firmware versions, this option was only available via the CLI.
See Local-in policy. Enable the Lo...
@hexank Yes there has been changes in the layout, but you can still run
the parallel packet captures on the GUI. You just will have to go to
Diagnostics under Network, and start on new capture, close it, and then
start it again on different interface...
Hello @sam653 You can refer to following resource:
https://community.fortinet.com/t5/FortiGate/Technical-Tip-FortiGate-SSL-VPN-best-practices-guide/ta-p/331260
This will walk you over the steps to strengthen the SSL VPN
Hello @t0mas89 Since this is the application crashing itself, I would
say to check the event viewer (if on Windows) to see what is causing the
crash. Updating the drivers might help to. Moreover, you mentioned 7.2.4
is the only version available in y...
Hello @HelpdeskGbank Would need more information on this, is this a
standalone Forticlient or managed by the EMS? What is the Fortigate OS
version (if it is the Fortigate) that you are connecting to? Moreover,
always check the compatibility matrix:
h...
Hello @GiuseppeB To answer you question, yes, the monitored interface if
goes down, the failover should occur, (meaning, the secondary device
would become active). However, you have put the HA links itself here, I
am not sure if you want them specifi...
