Hi, I have FortiAP 431F connected to a FortISwitch M426E. I connected
the 2.5Gbps Port of the FortiAP to a 2.5Gbps Port on the Switch and the
1Gbps Port of the AP to a 1Gbps Port on the Switch. I configured an
active LACP Trunk on the Switch and set ...
Hi, I have two FortiAPs on a customers Site and a lot of smart home
devices. All of them use 2.4 Ghz and connect to only one AP. I switched
on FortiAP and Frequency Hand-off but that doesn't change much. Is there
a way to allow only specific MAC addr...
Hi everyone, I have a FAP 221C on a remote site. It is connected to the
network 192.168.178.0/24 on the remote site and connects via capwap to
the FG on our main site. Now I tried to use split tunneling on the FAP
Profile. I want the remote traffic t...
Hi everyone. I just started to use automation for alert mails since I
can choose more detailed options to trigger the mails. But the mails are
formatted in a bad way. Does anyone know where I can change the
mail-template? I would like to include the ...
Hi everyone, FG61E active-active HA Since v.6.2.3 we have very high
memory usage. The Fortigates go into conserve mode all the time and i
can't get the memory any lower than 77%. I disabled unrequiered
features, switched some policies from proxy-base...
Hi, thanks for your replies. I had LACPs configured with multiple port
speeds in the past and it worked fine. I think I found the problem in
the logs. I created the LACP for both ports and disabled STP. When the
AP boots I can see in the logs "primar...
Andy Bailey wrote:Hi Jannik and JerryPWhite_FTNT, I meant to ask you if
you had seen the "anycast" section in the FortiGate 6.2.3 cookbook
(https://docs.fortinet.com/document/fortigate/6.2.3/cookbook/734277/fortiguard-third-party-ssl-validation-and-a...
