Good morning all! After many read-throughs, I don't believe that what I
would like to do is possible but I figured I'd toss it out here in case
I have missed something. We have a primary and secondary ISP for
redundancy, but rather than use the lines...
Good morning all! I'm looking for a way to perform live monitoring on
our 100e box. What I am looking to do is determine what traffic (ports,
destination IP, status, etc.) is being generated by a specific IP in
real time. Example: Phone traffic gener...
That might sound like I need to verify IP addresses, but that is not the
case. I have an interesting problem that I need to address and was
wondering if anyone had any insight or experience with this issue. We
recently purchased a 100e to replace an ...
Good morning! I am looking for best practices/recommendations for
utilizing the built in switch on a Fortigate 100e, in particular with
configuring the switch to split the ports between internal LAN and DMZ.
I do not need all 16 ports on the Fortigat...
Good morning and thank you for the replies! The recommendations come
close to what I am looking for, but I am either missing something or I'm
not interpreting the data correctly. I'm expecting to be able to see the
traffic that is blocked, or if traf...
I did find some WAN2 information, but everything looked correct. It
looks like I've been chasing my tail though as troubleshooting what I
thought was a completely unrelated issue ended up correcting my problem.
I had to run "diagnose firewall iprope ...
Thank you both for the recommendations! For some reason all odd numbered
IPs were attempting to route through my secondary WAN interface rather
than the primary. Turning that off instantly corrected the problem, just
not necessarily with the desired ...
Hey Mike, Thanks for the reply. Hardware over software switch makes
sense, but I get a "System error" when attempting to configure a
hardware switch. Using software switch with all other settings being the
same, everything goes through without a hitc...
