Hi,when viewing "FortiView sessions" I'm seeing [object Object] in the
source column instead of IP.Don't remember it was like that before...
(currently on 7.4.9) any ideas would be appreciated,Thanks...
Hi, I would like to get an email alert when my sd-wan fail over from one
connection to the other.found this link for older FortiOS but i don't
have this event in FortiOs
7.4:https://community.fortinet.com/t5/FortiGate/Technical-Tip-SD-WAN-link-status...
Hi,I've got FortiExtender connected to a switch that is connected to the
Fortigate.The FortiExtender works great and is a part of the sdwan
(checked and working).In the Extender menu it shows as online but in the
Topology and in the Dashboard the Ext...
Hi,I'm struggling to understand/choose how to setup a new FortiExtender
201E.My setup is FortiWifi -> FortiSwitch (POE) -> FortiExtender.The
Fortiextender is connected by port4 (which is the only poe on it) to the
Fortiswitch on a vlan with fabric co...
Hi,I had few power losses at home lately (no UPS) and every time my
FortiWifi 60F loads up all devices at home don't get any ip address from
the DHCP, not the wifi devices nor the wired devices.if i set a manual
ip address to my computer everything i...
Rebooted the device many times and it was unplugged for a while when i
hanged it on the wall... ;)Unfortunately, it didn't help and device
still shows as offline (while working just fine)
Hi, Thanks.I've set up an health check on my wan1 (fiber).I made a test,
started pinging 1.1.1.1 and went to take the fiber out, it jumped to the
Fortiextender as expected and worked perfectly.I then took the fiber
back in, pings (active connections ...
Great, Thank you! :) Do i need to set Performance SLAs too or is it
optional?Lets say my ISP connection is dead but i do have a link because
i have converter from fiber to ethernet (so link is always up although
there is no real data), how does it kn...
Thanks for the reply.Kept reading and understood the WAN/LAN extension.
Managed to Set my FortiExtender in WAN mode with Capwap protocol (vlan
mode didn't work)trying to understand how to set the sdwan rules so it
will always be on wan1 and failover ...
