Description This article describes how to disable email notifications
for admin login attempts when automation stitches are not configured
Scope FortiOS 6.4.x. All FortiOS 7.x versions. Solution In the previous
versions, email alerts were sent from C...
Description This article describes the process of troubleshooting
traffic flow when an IPPool is configured under the firewall policy for
IPsec tunnel traffic. Scope FortiGate all versions. Solution In common
situations, when an IPsec VPN is created ...
Description This article describes how to view real client IP on
FortiProxy when user is hidden behind another proxy device with
x-forwarded HTTP headers configured to send ClientIP inside HTTP headers
Scope FortiProxy 7.0+ Solution The solution belo...
Description This article describes the process of installing a
FortiOS-VM in the Hyper-V platform for testing purposes with a permanent
Trial License Scope FortiOS-VM. Solution To install a FortiOS-VM in a
hypervisor platform a FortiCare account is r...
Description This article describes how to troubleshoot FortiGate IPsec
VPN when certificate-based authentication is enabled but the certificate
private key fails to load from the certificate repository. Scope FortiOS
7.0+. Solution As a first step of...
@GraemeM You can fix it by adding more subnets under phase2
selectors:Adding source and destination subnets to IPsec VPN phase 2
configurations | FortiGate-7000 5.4.9 | How to configure IPsec remote
access with... - Fortinet CommunityFortinet Documen...
Hi Umesh, You can follow this guide to setup some hard-timeout value for
users.Hard timeout for Dialup IPSEC VPN Tunnel - Fortinet CommunityThis
will force them to reauthenticate or disconnect form the session if they
fail to do so.
@hemanth4 Thank you for your post here. This seems most likely like a
Splunk configuration issue so I think it is better to ask on that forum.
After doing a little research I found this link that might point you in
the right direction in case FortiGa...
Hi @trymeee Thanks for the feedback. Can you mark my answer as a
solution so other guys that might require the same information, have it
easier to find this post? Thanks
@trymeee There are some ways to do it.First you enable if you want
strong cyphers or weak cyphers, and then you choose which one to use
from cypher suite:FortiGate encryption algorithm cipher suites |
FortiGate / FortiOS 7.0.0 | Fortinet Document Lib...