I’ve not tried this before and am stumped. I have a FGW40C in
Transparent Mode running 5.04.. I have setup 2 SSIDs one for internal
network users and one for guests. I am able to connect to the SSIDs, but
no IP address is handed out. I cannot find ...
I’d like to create a Captive Portal and have the user check the
agreement box, but not have to provide any credentials to accomplish
connect. When I create the captive portal it requires me to enter a user
group, and each user in the group is requi...
Just had an external scan performed on our network? The Fortigate 50B
failed because of CVE-2009-3555, which is a TLS Protocol Session
Renegotiation Security Vulnerability. We are running 4.0MR3P10. I looked
at new patches, and none of them address t...
I have a unit that is not working properly and want to erease the flash
and TFTP a new image to the device. It is a 20C and only has a USB
interface. How can I erase the flash on this and install a new image?
Typically I break the boot process on ser...
I have a FWF40C with 4.0MR3 Patch 9. It is licensed up and on the status
page; it has the green check mark and vulnerability is licensed. In the
UTM section there is no vulnerability scan section. In the Log & Archive
Access, there is a Vulnerability...
There are several ways this could be accomplished. The easiest would be
to install a new switch and attach it directly to the Internet. Each
VDOM has a LAN and WAN port. The LAN ports can be on the same IP range.
Each VDOM will use NAT on the WAN int...
https://[firewall mgmt IP]/p/firewall/sniffer/ I just tried this and it
appears to be there on my 110C, but the only interfaces available for
the capture are in the root VDOM. Interfaces in other VDOMs do not show
up. I am curious what the URL is to ...
Also forgot to mention that you will need to put policies and routes in
to make it all work. The commands on my previous post are for a route
based VPN (interface mode). Jack
As long as you use the default setting at the main site, here is the CLI
commands to build an interface-tunnel config vpn ipsec phase1-interface
edit " vpn-1" set interface " wan" set proposal 3des-sha1 aes128-sha1
set remote-gw (address of remote si...
Issue Solvee... Can' t be done... A work-around would have been to build
2 VDOMs and set wireless up on the NAT VDOM, but the FGT40C since the
release of V5.xx does not support VDOMs.