I’d like to create a Captive Portal and have the user check the
agreement box, but not have to provide any credentials to accomplish
connect. When I create the captive portal it requires me to enter a user
group, and each user in the group is requi...
There are several ways this could be accomplished. The easiest would be
to install a new switch and attach it directly to the Internet. Each
VDOM has a LAN and WAN port. The LAN ports can be on the same IP range.
Each VDOM will use NAT on the WAN int...
https://[firewall mgmt IP]/p/firewall/sniffer/ I just tried this and it
appears to be there on my 110C, but the only interfaces available for
the capture are in the root VDOM. Interfaces in other VDOMs do not show
up. I am curious what the URL is to ...
Also forgot to mention that you will need to put policies and routes in
to make it all work. The commands on my previous post are for a route
based VPN (interface mode). Jack
As long as you use the default setting at the main site, here is the CLI
commands to build an interface-tunnel config vpn ipsec phase1-interface
edit " vpn-1" set interface " wan" set proposal 3des-sha1 aes128-sha1
set remote-gw (address of remote si...
Because you have public addresses on your LAN side of the Cisco, and you
are looking to have private address on your lan and you want to only use
1 device to do this, I would setup 2 VDOMs, one called ISP and the other
called Private. the ISP VDOM sh...
