I mean, i have two physical switch connecting to a fortigate 200D and
these two switches are using differnt VLAN IP subnets therefore the
fortigate is acting as a router(static routing, not using dynamic). The
two switches had MTU 9000 jumbo configur...
hi all,wanna ask a dumb question about limiting access from internet. i
have a fortigate 200D acting as edge between internet and private
network.the WAN interface on 200D got some ports open (for quick access,
i know it's not safe) that maps to priv...
got a fortigate 200D old firewall in my company's lab environment.i'm
constructing a network topology with 200D and two switches(other brand),
and these two SW are providing redundancy for end devices/servers. the
topology is shown in attached figure...
a FortiGate 200D firewall on my side needs to update the
firmware.currently its firmware verison is v5.0,build0318 (GA Patch 12)
i tried searching for recommended upgrade path of firmware for this
device in here https://docs.fortinet.com/upgrade-tool...
Just got an old fortigate 200D firewall but not familiar with it.I wanna
aggregate two ports together and link them to downlink 2 switch ports.
would like to know:is it doable to aggregate 2 ports together and link
to switch ports (to increase bandwi...
@toshi esumithanks for the answer! i forgot to say...i doubt that
whether the routing mtu should be configure on the fortigate to avoid
packet fragmentation or not cause i need a consistent MTU size
throughout the routing and connection between end p...
hey guys thanks for answering my dumb question~~! frankly speaking, i'm
talking about WAN VIP address 100.100.100.100:2345 mapping to private
network FTP service 172.24.3.1:5432,and allow specific internet IPs to
access 100.100.100.100:2345 for FTP f...
hi guys,really appreciate your answers!! my apologies to the bad
statement on question 2.here's the thing, I'm planning to use CAT6a
cable to link a 10Gb switch and this fortigate 200D.two 10Gb ports on
switch will be aggregated and connect to 200D's...
