Hey everyone,I'm working with a FortiGate 40F setup, using an ADVPN with
IPsec to connect 1 hub and 2 spokes. For routing internal traffic
through the ADVPN tunnel, I'm relying on SD-WAN rules and SLA
checks.Just to add some context, I'm using my ISP...
Hi there, I am currently trying to configure BGP for my SD-WAN IPv4 over
IPv6 ADVPN environment, following the guide from Fortinet’s
documentation on Active Dynamic BGP Neighbor Triggered by ADVPN
Shortcut→Active dynamic BGP neighbor triggered by ADV...
Hi everyone, I'm using FortiGate version 7.4.4 and have configured DDNS
with FortiDDNS on three devices: two FortiGate 40F units and one
FortiGate 60F. The WAN interfaces on all devices use IPv6, and each
device has been configured with FortiDDNS usi...
Hello @Umer221 I checked the VPN event logs on the hub, and it looks
like whenever one tunnel (like to Spoke-A) connects, the other tunnel
(to Spoke-B) disconnects. This keeps happening back and forth, so only
one tunnel is active at any time, which ...
After performing a soft reset, there is still no bgp routes inserted
into the routing table.In fact , I even can't ping the hub router's vpn
IPsec tunnel interface, even though it's in my IPv6 routing table.The
firewall policy allows all IPv4 and IPv...
