Hi there, I am currently trying to configure BGP for my SD-WAN IPv4 over IPv6 ADVPN environment, following the guide from Fortinet’s documentation on Active Dynamic BGP Neighbor Triggered by ADVPN Shortcut→Active dynamic BGP neighbor triggered by ADVPN shortcut 7.4.1 | FortiGate / FortiOS 7.4.0 | Fortinet...
After configuring BGP, I tried to check the BGP routing table using the command:
get router info routing-table bgp
However, I am receiving the message "No route available."
What could be the possible reasons for not seeing any routes in the routing table..?
Below is the current BGP configuration on my hub router.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
FortiGate-60F (bgp) # show
config router bgp
set as 65100
set router-id 10.200.1.1
set ibgp-multipath enable
config neighbor-group
edit "EDGEv6"
set remote-as 65100
set update-source "advpn-hub"
next
end
config neighbor-range6
edit 2
set prefix6 2001:db7::/64
set neighbor-group "EDGEv6"
next
end
config network
edit 1
set prefix 192.168.0.0 255.255.0.0
next
end
Below is the current BGP configuration on my spoke router.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
config router bgp
set as 65100
set router-id 10.201.1.1
set ibgp-multipath enable
config neighbor
edit "2001:db7::100:200"
set advertisement-interval 1
set remote-as 65100
set update-source "advpn-spoke"
next
end
config neighbor-group
edit "spokesv6"
set passive disable
set remote-as 65100
set update-source "advpn-spoke"
next
end
config neighbor-range6
edit 1
set prefix6 2001:db7::/64
set neighbor-group "spokesv6"
next
end
config network
edit 3
set prefix 192.168.1.0 255.255.255.0
next
end
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
Hello @ctyctyctctcty ,
I would suggest to soft restart BGP route as below and if we still have issue, you can run bgp debug as mentioned:
After performing a soft reset, there is still no bgp routes inserted into the routing table.
In fact , I even can't ping the hub router's vpn IPsec tunnel interface, even though it's in my IPv6 routing table.
What could be causing this issue?
Here’s a screenshot from one of my spoke interfaces.
I can provide the configuration of the devices, so please let me know if needed.
My Background: I apologize for my limited experience. I’m currently conducting tests for the implementation of FortiSD-WAN in my company, building an SD-WAN environment with a hub (60F) and two spokes (40F). I appreciate any assistance you can provide.
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1696 | |
1091 | |
752 | |
446 | |
228 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.