Dear Concerns,Can I perform application-based routing on the FortiGate
firewall? I have two ISPs (Primary & Secondary), and I want specific
application traffic such as Microsoft Teams to go through the Secondary
ISP.I attempted to configure this usin...
Dear Concern,I had established primary and secondary IPsec tunnels with
a cloud server through two different ISPs. Both tunnels had been working
properly for the last 2.5 years. However, for the past few days, I have
encountered an issue with the pri...
Dear Concern,I need to configure an IPSec VPN on my FortiGate firewall,
where user traffic should be NATed to a specific set of dynamic IP
addresses before reaching the remote side. This is necessary because the
remote side will only allow traffic fr...
Dear Concern, I need to access a website that is currently being blocked
by my FortiGate-201 running FortiOS v7.6.2.F. I have attached a
screenshot for your reference. The website is authentic, and I would
like to specifically allow or exempt it so t...
Dear Concern,I need to downgrade the firmware of my FortiGate-201F
firewall from 'v7.6.2 build3462 (Feature)' to 'v7.4.7 build2731
(Mature)'. How can I do this? Please provide the steps. On the Fortinet
Support Portal , there is an option to check th...
Hi,I have already tested this, and according to the debug logs, the
message ‘processing notify type NO_PROPOSAL_CHOSEN’ appears on Phase 2.
As far as I understand, this usually occurs when the Phase 2 parameters
on both ends do not match—am I correct...
Dear All,I found the solution to allow multiple SSL-VPN connections for
a Specific User via GUI in FortiGate-201F (v7.6.2 build 3462). Step 1:
Create a New User Group (for the specific user)Log in to the FortiGate
GUI.Navigate to: User & Authenticati...
Dear AEK, Yes, secondary IP addresses are also defined on the WAN
interface, meaning I have defined one IP address from the static IP
address pool provided by the ISP on the WAN interface, and the remaining
IP addresses are defined as secondary addre...
Dear Suraj, Thanks for your response and suggestionAccording to you, I
noticed that UDP was disabled in the DNS protocol, so I enabled it.
After that, 8.8.8.8 or 8.8.4.4 are no longer unreachable, but the
latency is still varying between yellow and r...
