Description This articles describes a known issue where users may fail
to match a group if the DN characters exceed 127 characters causing
subsequent groups to fail. Scope FortiGate. Solution When a user
attempts to log into the IPSec VPN (IKEv2) wit...
Description This article describes one method of copying and pasting
configuration that contain the special character '?' using batch mode.
Scope FortiGate. Solution By default, it is not possible to paste a
question mark (?) in the CLI console. It w...
Description This article describes troubleshooting one issue where IPSec
IKEv2 fails to connect and in the IKE debugging the following messages
'sent IKE msg (AUTH_RESPONSE)", "negotiation timeout, deleting',
'connection expiring due to phase1 down' ...
Description The article describes one method to configure IPsec VPN
using IKEv2 and have FortiGate assign IP addresses to clients. Scope
FortiGate, FortiClient. Solution In this scenario, this setup was using
FortiGate v7.6.4 with multi-VDOMs enabled...
Description This article describes how to resolve the 'reverse path
check fail (bad src), drop' issue for NAT64 traffic originating from
outside the FortiGate. Scope FortiGate. Solution In this scenario, a
client is attempting to access RDP over the ...
Hello kaCo, Do you know what FortiClient firmware you have installed?
The latest FortiClient v7.4.2 support Ubuntu 22.04:
https://docs.fortinet.com/document/forticlient/7.4.2/linux-release-notes/136392/product-integration-and-support
Also there are r...
Hello dcorrada, You mention that the FortiClient does not appear in the
tray. Could you have a look at this article:
https://community.fortinet.com/t5/FortiClient/Technical-Tip-FortiClient-not-appearing-in-system-tray-on/ta-p/344280
