- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
FortiWifi 40F Lost Packet Capture after upgrade to 7.46
Access denied when trying to start cap.
Any ideas?
Tried this route as well - https://community.fortinet.com/t5/FortiGate/Technical-Tip-FortiGate-Disable-Hardware-Acceleration/ta...
Solved! Go to Solution.
- Labels:
-
FortiGate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello KnealPeert,
Are you logged in as a Super Admin? And have you tried saving the packet capture again in a different browser?
Anthony.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello KnealPeert,
Are you logged in as a Super Admin? And have you tried saving the packet capture again in a different browser?
Anthony.
Created on ‎12-24-2024 04:37 PM Edited on ‎12-24-2024 04:42 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Interesting - access denied in Firefox but works fine in Edge.
Was just odd that this was my first capture since upgrading so I blamed it on the upgrade.
Thanks for the tip.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @KnealPeert ,
Just a quick check, is there anything suspicious in crashlog ?
diagnose debug crashlog read
regards,
Sheikh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Not sure how many upgrade steps you took to get to 7.4.6 from the original version. But the best practice is to check any configuration errors at each upgrade with:
diag debug config-error-log read
Did you do this and saw anything in it? If you didn't, but you haven't done any reboot after the last step, at least you can still see the result of the last upgrade step to get to 7.4.6. Do you see anything in it?
Toshi
