Hi all.I have an annoying setup, where an l2tp client (a server machine)
using native windows L2tp/IPsec client connects to the customer's
office. The problem is, that customers' LAN is 192.168.0.0/24, the
server's IP is 192.168.0.20. Naturally I can...
Good morning, My question is probably more of theory nature: Our
customer is using Proxy IP telephony provider. For that we had to
configure Custom Service to communicate with the provider. Recently our
customer started receiving multiple spam calls ...
Anyone experiencing issues, that FGT60F's do not get the firmware
upgrade notification, and when you try to download and install firmware
manually it says, that firmware is not for that model? (I downloaded the
fw marked as designated for 60F). it se...
Thanks for the KB, in my case, my server machine is looking at the
internet directly, and directly connects to the Fortigate via windows
native client, on the other side. So, basically I have only one half of
the setup described. But, it's worth givi...
I would link port 2 and port 3 into a software switch, and configure
DHCP relay in interface settings for the software switch, pointing to
DHCP server 10.20.12.1. And in your dhcp settings the default route
should be pointing to whatever IP address i...
Hi sagha, Thank you for the explanation and guidance this was really
helpful. The debug flow shows that the incoming packets do not hit the
SIP communication rule, and are dropped by the implicit deny rule.
