Hello everyone, I hope you are all doing well. I would like to convert
my Cisco ASA NAT/PAT rules to a FortiGate FGT40. Can you guide me? I've
tried, but I can't seem to find the source and destination of the PAT on
the FortiGate. ASA Rule pic : Wher...
Hello,I hope you are well,I need your help "if possible" to configure a
dial-up interface on a sub-interface in order to use it for an IPSec VPN
link (First Is it possible ?)I tried to configure it by creating a
standard VPN tunnel behind a NAT, then...
Hello, I hope everyone is doing well. I have an isolated adreese to
internet and I would like to open the flux only to the Office365 mailbox
(App/Web access). FGT200DFortiOS : 5.2.7 Build718GA Thank you in advance
for your return. Regards.
Hello Hbac,Thank you for your return. I have two types, NAT and PAT, as
shown in the screenshot. Now on the FGt I have activated the centralNAT
to have access to nat and ip pool + VIP (activated by default). The
problem is that on the ASA it's simple...
Hello Guys, Thank you all for your feedback and informationis it
possible to get an idea of when the next .M(Mature) 7.4.x version will
be released? Reagrds.
so I can't modify the interface after creating the tunnel Okaaayyy
Otherwise, for my scenario above, the interface that I need to create is
a Dial-Up interface ? because on the Old_ASA to be I have a Dial-Up
interface. Ok I'll try and get back to you...
as I mentioned above in the topology I have a vpn site to site with a
remote site in dynamic IP so I have to configure the primary site
interface (VLAN) in dynamic behind Fortiwan(Forwarding/NAT/source ip
public)I'll try to modify it in CLI and get b...