Re: Anomaly - udp_flood

pbangari · 10-25-2023

Description This article describes how to configure a secure (HTTPS) download of a PAC file from FortiProxy. Scope FortiProxy. Solution There is a new feature introduced in FortiProxy 7.4.0 version which can be used to configure a secure (HTTPS) down...

pbangari · 09-28-2023

Description This article describes information on support for dynamic addresses to security-policy in NGFW Policy mode. Scope FortiGate. Solution Starting FortiOS version 7.4.1, in FortiGate deployed in NGFW Policy mode, it is possible to use dynamic...

pbangari · 09-15-2023

Description This article describes how to configure Proxy policy while using a web proxy forwarding server. Scope FortiGate. Solution In a proxy setup the Forwarding-server configuration is as below: config web-proxy forward-server edit "proxy-1" set...

pbangari · 09-05-2023

Description This article describes troubleshooting steps to resolve cases where authentication codes are not received through SMS while using a FortiGuard SMS service. Scope FortiGate. Solution Check the FortiGuard server status and ensure the device...

pbangari · 08-22-2023

Description This article describes the differences between using the registered location or the physical location of IP addresses. This helps configure a correct firewall policy configuration based on requirements. Scope FortiGate. Solution Fortinet ...

pbangari · 12-01-2023

Policy & Objects >> IPv4 DoS policy>> create new, you should see default values.

pbangari · 12-01-2023

You may refer: https://community.fortinet.com/t5/FortiGate/Technical-Tip-Recommended-Release-for-FortiOS/ta-p/227178

pbangari · 11-30-2023

You can verify if the source IP address is something you recognize or trusted one if yes, then you can consider to increase the threshold value for this source IP or set the action to monitor where this IP address is called as the source.

pbangari · 11-30-2023

You can try 'unset monitor' under IPSec configuration and use link-monitor instead as in this case both the primary and secondary tunnels will be up and traffic failover should happen much quicker. https://community.fortinet.com/t5/FortiGate/Technica...

pbangari · 11-23-2023

Default action is 'block' for the unrated url however you can use the static URL filter to override the fortiguard categorization. https://community.fortinet.com/t5/FortiGate/Technical-Tip-Using-a-static-URL-filter-feature-to-allow-block/ta-p/193086

User Statistics

User Activity

Technical Tip: Configure secure (HTTPS) download of a PAC file

Technical Tip: Support for dynamic addresses to security-policy in NGFW Policy mode

Technical Tip: Proxy policy configuration for web proxy forwarding server

Troubleshooting Tip: Not receiving FortiToken Mobile authentication code from the FortiGuard SMS service

Technical Tip: Registered location and physical location of IP addresses