Description This article addresses the error message 'This Connection Is
Not Private', which commonly occurs when accessing any website. Scope
FortiGate. Solution This error, 'This Connection Is Not Private',
usually occurs due to an issue with the S...
Description This article describes how to configure FortiGate to
automatically send a daily security rating summary to the security team
via email for regular monitoring and response. Scope All FortiGates.
Solution To automate the process of sending ...
Description This article describes how to fix the error "'nother
installation is in progress'. Typically encountered during FortiClient
installation or uninstallation. This issue is often caused by conflicts
with other installation processes, particu...
Description This article describes how to configure an IPsec VPN between
two FortiGate devices where traffic coming from SITE-B which should be
NATed. The traffic from SITE-B must be NATed because SITE-B and SITE-C
use the same subnet, and it is desi...
Description This article describes how to allow IPsec VPN port 4500,500
and ESP protocol access to specific IP addresses only. Scope FortiGate.
Solution For Instance: IPsec VPN site to site with the remote peer of
10.10.10.1 which opened IKE port 500...
Hello,The delay in recovery when one line disconnects in your SD-WAN
IPsec aggregation setup could be caused by multiple factors, such as the
link health check interval, the failover threshold, or the way the
sessions are handled during failover. To ...
Hello, Thank you for the details provided. The error
PR_CONNECT_RESET_ERROR typically indicates that connections are being
reset, which can happen if SSL inspection or certificate handling has
changed after the upgrade. Here are a few steps to troubl...
Hello Robert,Thank you for the detailed information. Based on your
current setup and requirements, here are the key steps and
considerations to help you achieve a transparent VLAN configuration
between the WAN (VLAN 6) and LAN: Transparent VLAN Overv...
Hi Mohammed,Application control not visible in the GUI after upgrading
to v7.6.0This article describes a known issue where Application Control
is no longer visible in the FortiGate Web GUI after upgrading to FortiOS
7.6.0. Notably, this issue only oc...
Hi, It sounds like you might be dealing with packet fragmentation or
integrity issues during transfer. I recommend switching to SFTP or FTPS
instead of plain FTP, which provides better encryption and integrity
checks. Also, try adjusting the MTU/MSS ...
