Description This article describes why a valid SSL certificate is
necessary and how to Install the newly generated certificate on
FortiGate for HTTPS access and SSL VPN. Scope FortiGate v7.0.x and
later. Solution The Certificate can be used for clien...
Description This article explains how to configure multiple DDNS entries
on a single interface or multiple interfaces. Scope Any supported
version of FortiGate. Solution A situation may arise where single or
multiple DDNS entries are needed on FortiG...
Description This article describes how to Configure DNS over TLS on
Fortigate with 3rd Party Global DNS. Scope FortiGate v 7.0.4 and later.
Solution Traditional DNS queries and responses are sent over UDP or TCP
without encryption. This is vulnerable...
Description This article describes the policy route behavior with link
monitoring. Scope FortiGate 7.0.1 and later. Solution Policy routing
allows specifying an interface to route traffic. This is useful when it
is needed to route certain types of ne...
Description This document describes how to configure the SSL-VPN with
Split tunnel configuration in which the firewall address configured
becomes a trusted destination that will not be tunneled through SSL-VPN.
All other destinations will be tunneled...
Hello chrishantha, You can add the variable %%date%% to name the backup
with the current date stamp. For example: 'backup-%%date%%.conf' would
be saved as backup-2023-01-11.confexecute backup config ftp
backup_%%date%%_%%time%%.conf 192.168.55.4 test...
Hello OliverHeinz, Yes, you can create a separate VDOM and add it in the
SDWAN Zone and get the setup working but still on that VDOM you've to
configure all the required policies and routes based on your
requirement. And also as the client is dual st...
Hello jm-barreto, Yes the document is a little confusing, you've to keep
in mind that FortiGate will not allow more than 15 characters while
naming the IPSEC tunnel, that is a software limitation, when you
configure a normal VPN you'll not have to wo...
Hello Jakob-AHHG, You can disable the warning use below command config
system globalset gui-firmware-upgrade-warning disable end
https://docs.fortinet.com/document/fortigate/7.2.4/administration-guide/475378/firmware-upgrade-notifications
Hello jm-barreto, Please check the below link explaining this :
https://community.fortinet.com/t5/FortiGate/Technical-Tip-IPsec-VPN-phase1-interface-name-characters/ta-p/193193?externalID=FD31562
Consequences for dynamic phase1 users using interface ...