Description This describes how to use Optional VLAN ID in Tunnel type
SSID configuration. Scope FortiGate/FortiAP. Solution When using a
Tunnel-Mode SSID, the FortiAP will encapsulate wireless traffic within a
CAPWAP tunnel before sending it to the F...
Description This article describes which service to allow in the inbound
VIP firewall policy when virtual IP port forwarding is configured with a
different external port than the internal port. Scope FortiOS v5.6 and
later. Solution This article assu...
Description This article explains common behavior seen by users after
connecting to the remote access VPN on FortiGate in full tunnel mode
with FortiClient. Scope FortiGate when making connections to the remote
access VPN. Solution When users connect...
Description This article describes the power supply failed log issue
after the firmware upgrade to 7.0.8. Scope Software: Firmware
v7.0.8.Hardware: FortiGate-8xF and 10xF. Solution In FortiGate Firmware
v7.0.8, the PSU Alarm log and SNMP trap have be...
Looks like the traffic is going out via the VPN tunnel, You might wanna
look at the remote FortiGate.Check the reverse route and firewall
policy, Try to take the flow trace debugs on the remote side.diag deb
flow filter addr x.x.x.x <-- ip you are pi...
Try running a sniffer for the ICMP traffic on both Fortigates and see if
the traffic is making it to the other side or not.diag sniffer packet
any "host 10.0.0.41 and icmp" 4 0 l