Most Liked Posts Recent Solutions
No Content Available

User Activity

Description The article speaks about how to clear routes after changing the BGP vrf-leak configuration. This is applicable for FortiOS v6.4.0 and later. Scope FortiGate v6.4.0 and later. Solution After adding/deleting the prefixes in the route-map co...
Description This article describes the 'capability-route-refresh' in BGP. Scope FortiGate. Solution 1) By default, the 'capability-route-refresh' is enabled under the BGP neighbor. # config router bgp config neighbor edit set capability-route-refres...
Description This article talks about how to configure PIM SSM (Source-specific Multicast). Scope FortiGate. Solution 1). In PIM SSM, Multicast Receiver Device must be manually configured with the Multicast Source IP and Group IP. 2). PIM SSM must be ...
Description This article speaks about the workaround to allow the multicast traffic to flow between the member interface of the same zone. Basically, when the Multicast interfaces are members of the same Zone then there are below two limitations to c...
Description This article speaks about the correct way to configure IPsec over npu-vlink between two VDOMs. Scope Solution Consider the points while configuring the IPSEC over npu-vlink between two VDOMs. - It is not possible to use the npu-vlink inte...