Re: mac addressed-based policy is works on fortiga...

rmreddy · 11-01-2024

Description This article describes how traffic flows when NAT is enabled in the IPv4 policy. Scope FortiGate. Solution When NAT is enabled in the IPV4 policy, the traffic will get NATted to the IP of the destination interface and will be forwarded to...

rmreddy · 11-01-2024

Description This article describes why it is impossible to configure a hardware/software switch, VLAN interface as both an HA monitor and heartbeat interfaces. Scope FortiGate. Solution Port9 is configured as a software switch, and a test VLAN interf...

rmreddy · 10-25-2024

Description This article describes why it is impossible to select the interface which has been selected in the management interface reservation in a policy or route. Scope FortiGate. Solution When the Management interface reservation is configured in...

rmreddy · 10-24-2024

Description This article describes why after upgrading the firmware device does not come up. Only the power LED is up. Scope FortiGate. Solution When connected to the console, the error 'unable to load OS, CPU profile stopping' appears. The above iss...

rmreddy · 09-25-2024

Description This article describes how to view BGP and OSPF options to configure. Scope All FortiGate. Solution By default the options to configure BGP, OSPF, RIP, Multicast, and policy route, as by default in feature visibility advance routing will ...

rmreddy · 06-21-2023

Hi, As you are configuring for SSLVPN using MAC based Please follow the below link for your reference how to restrict VPN based on MAC address.https://community.fortinet.com/t5/FortiGate/Technical-Tip-MAC-Address-check-on-SSL-VPN-connections/t... How...

rmreddy · 06-21-2023

Hi, However, if you are looking for normal IPV4 policy, you can refer the below link for your reference where special licensing is not required.https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-create-the-MAC-address-based-polici...htt...

rmreddy · 06-21-2023

Hi, Please follow the below link for your reference how to restrict VPN based on MAC address.https://community.fortinet.com/t5/FortiGate/Technical-Tip-MAC-Address-check-on-SSL-VPN-connections/ta-p/194337 However, follow the below link regarding the M...

rmreddy · 06-12-2023

Hi, Usually while connecting to VPN, should match to the group, portal and policy as well. However, to check why user is not able to connect VPN it will be helpful with SSLVPN debug logs.

rmreddy · 06-07-2023

Hi, If trying to delete the user make sure there are no references to the user and also un-assign the token for the user. If you are trying to send the activation code to activate from new mobile, you can send the activation code, the option to send ...

User Statistics

User Activity

Technical Tip: How traffic will be forwarded when NAT is enabled in IPv4 policy

Technical Tip: It is impossible to configure a hardware/software switch, VLAN interface as both HA monitor and heartbeat interfaces

Technical Tip: Impossible to configure policy and routes with the interface selected for management interface reservation

Troubleshooting Tip: After upgrading the firmware device does not come up. Only power LED is up

Technical Tip: Unable to view options to configure BGP and OSPF

Re: mac addressed-based policy is works on fortigate 200E 6.4.11?

Re: mac addressed-based policy is works on fortigate 200E 6.4.11?

Re: mac addressed-based policy is works on fortigate 200E 6.4.11?

Re: Firewall group mismatch from VPN SSL group

Re: Cannot delete fortitoken user "The entry is used by 1 other entries"

Re: mac addressed-based policy is works on fortiga...

Re: WAN interface policies

Re: Migrating from Fortigate 201E to Fortigate 601...

Re: Can I delete "lan" Hardware Switch in 40F

Technical Tip: Enabling and using the admin discla...

Re: mac addressed-based policy is works on fortiga...

KCS