I have a fortigate vm running in azure which is currently pay-as-you go.
I've now purchased a license and want to apply it but apparently this
can only be done when the VM is created? What would be the best route to
do this? Config backup, delete VM,...
I have a pair of 200e that I'd like to get into an HA pair. My issue is
that I will not be able to cable the passive one the same as the primary
for a few months because reasons. I want to link them via the HA port so
that the primary unit automatica...
Currently running ADVPN to connect our branches to our core. I've added
ADVPN-BACKUP for branches which uses the 2nd ISP in our core. It
connects fine and can access resources in the core. What it can't do is
communicate with other sites that are on ...
I'm setting up Duo MFA for admin logins. It does the LDAP query, sends
me the push buuuut then just proceeds with the login. Doesn't matter if
I ignore the prompt or hit accept/decline it just sent me right in.
Would this be a Duo or Forti issue? Dev...
So I have one FortiGate that I get cannot get synchronized after a
firmware update. It was consistently in 'Conflict' status. Had it happed
with a couple other and retrieving the config would resolve it... but
not with this one. It would fail. I dele...
1B) I understand the monitoring portion of it and if everything was
cabled correctly, I'd want to monitor all the ports in use. But since I
don't want the failover to happen, I don't want to monitor anything,
right? I've been scouring the docs but th...
1) I'm trying to keep it simple for now until it can be cabled properly
so I don't want anything plugged into the passive unit other than what's
required to mirror the config. I'm not sure which interface I should be
monitoring or is it even required...