I had to migrate to a Fortigate from another vendor - According to
Fortigate support Hardware acceleration doesn't work on a software
switch. My setup is as follows: WAN1 -> Internet LAN1 = WiFi AP in
bridge Mode LAN2 = MacLAN3 = MACLAN4 = PiHole (DN...
My setup doesn't have any IDS or anything complex enabled;WAN1 -> ISP
(IPv4/IPv6, gigabit with low traffic (just checked, most in the last 12
hours was 30mbit/s for about a minute) NAT is configured for IPv4/IPv6
to the devices connected to the 60FID...
Hi. I just received this device today (60F) to replace some EdgeRouter
products and I'm having a hard time getting IPv6 to work. So far, I was
able to follow a guide here:
https://thorsten-on-tech.blog/2018/06/08/ipv6-with-prefix-delegation-on-fortig...
