I just recently installed two Fortinet 60D's firewalls in HA mode and
set to active/active. On both firewalls ports 6 & 7 are connected to
each other for heart beat connection. On port 5 of both firewalls they
are wired into a single Cisco 2960s swit...
I have a Fortinet 60D firewall running 6.0.4 firmware. I just added a
second ADSL line to the firewall on WAN 2. I currently have a ADSL line
on WAN 1. Both ADSL lines have static ip's and the speed is equal on
both links. Currently I have get 25mbs ...
I am currently running Fortinet 5.44 on a 100D firewall. Just recently
some users started to complain about poor quality of phone calls. I
started a wireshark on the VOIP vlan and ran RTP Stream analyzer on 30
mins of data that I collected. From look...
I have a Fortinet 100D firewall with two Internet connections connected
to the firewall with the following port setup. Port 16 is the fiber
connection to fiber provider at 1GB. On Wan1 I have a 100MB cable modem
connection. In my static route setting...
At a remote site I have a 100mb Internet connection coming into a
Fortinet 60D-POE Firewall. The users were complaining about slowness to
the Internet. If I plug directly into the Cisco 3750 switch and run a
speed test I get 30mb x 10mb. If I plug di...
Were are you seeing in the system where the PPPOE daemon freezing. I am
still having problems with the system load balancing it's goes over one
or the other.
Thank you all for your post. I am running 6.0.4 and looking at the
configure that was posted and compared it to my and it appears that I
needed to set enable under the config system virtual-wan-link and the
system started to work like it should. Than...
Thank you for the config.. I just ran mine and it's completely
different.. I am going to give yours a try and see what happens. What
Ver are you running? Here is a copy of mine. baggins wrote:status :
enable load-balance-mode : weight-based fail-dete...
Thanks Dave - I have set bandwidth ingress and outgress for WAN
connections and the distance for each connection is set 1. Yesterday I
was monitoring that connection periodically and noticed that it would be
maxed out at 25mbs and the other wan conne...
Currently I am running 5.4.4 build 1117 GA Regarding policies for each
Internet connection I have separate polices in place. I really don't
need WLLB the cable line is strictly for fail-over and I am not using no
zones. I did make a change to my fibe...
