Hi All, i recently subscribe a new ISP For secondly WAN line, below is
my config related to that two WAN line and my routing rules,all machine
under VLAN12 are able to access access and my local server without any
issues. but i cannot access my local...
Hi All, Below is my planning for my network structure, Currently i using
fortigate 100d with firmware v5.2.2,build642 (GA), refer to my attach
file, after i created the trunk port for my wireless access point for
broadcast multiple SSID with differen...
Dear all, currently i have a fortigate 100d with firmware version
v5.2.0,build0589. i planing to manage user policy with Identity based
policy feature. but i unable found this when i configure my policy. Any
one can teach me how to enable Identity ba...
Dear all, currently i have one fortigate 110c my firmware is
v5.2.0,build0589 , i have two ISP Provider WAN1 and WAN2 both distance i
configure 10 and able to dial up now. any 1 can guide me how to do WAN
load balance and fail over? thanks all
Dear all, i have a fortigate 100D version v5.2.2, i need to set a rules
to block all streaming video but only allow youtube, i have done the web
rating overrides youtube.com to custom group. but when i streaming video
on youtube keep show video error...
Hi Emnoc, Yes, i want each APs broadcast multiple SSID, but i dont know
how to configure trunk port and access port in fortigate, in this
environment don't have any management switch.
xsilver wrote:FortiOS 5.2.x , in contrary to 5.0.x or 4.3 do not use
sub-policy levels for identity based policies.It simply has users and
groups as part of base match pattern aside to source/destination IP,
Service etc. See GUI of the policy and "So...
ede_pfau wrote:hi, there is nothing really left to do. As long as you
have both default routes (0.0.0.0/0) in the current Routing table (see
Routing > Monitor) the FGT will use both paths. Just make sure that the
distance is equal. For load balancing...
ede_pfau wrote:hi, there is nothing really left to do. As long as you
have both default routes (0.0.0.0/0) in the current Routing table (see
Routing > Monitor) the FGT will use both paths. Just make sure that the
distance is equal. For load balancing...
