Hi, I have a task to double check a Fortigate's configuration, the
device is a 60F. This device has 2 WAN/ISP and obviously for failover in
case the primary fails. Recently, the primary did went down and all the
users in the office didn't have intern...
Hi, So I configured a managed Fortigate via Fortimanager, what I did was
1. add an address object2. added this address object to a dynamic group
For some reason it has been a day and I still don't see the new address
object on the managed Fortigate. ...
I'd like to setup 2 WAN on a Fortigate but not as Active-Active but
Active-Passive, so if ISP1 fails, it failover to ISP2 automatically.I
know Active-Active ispossible since you just needed to set policy-based
routing to do this but not sure with ISP...
Thanks @Debbie_FTNT I just checked the group and indeed it uses Per
Device mapping, I added the object there, pushed the policy and it
reflected on the FGT, Thanks guys for all the help. This is a good start
for the week and I hope everyone is doing ...
@Toshi_Esumi I login to Fortimanager, went to Policy & Objects > Under
Policy Packages > Object Configurations (left pane) > Addressess Create
New and after creating a new object added to Dynamic group where this
Dynamic group is under a Firewall Pol...
