We have 2 standalone Azure Fortigates (7.0) in a load balancer sandwich,
managed by FMG. We're looking to replace the Azure VPN gateway with
IPSec on the Fortigates to our onprem Fortigate cluster. I'm looking for
a reference design for the IPSec tun...
We can't find anything in docs or kb on this and what i'm reading on
redit is scary. when migrating a FG cluser to new boxes and you have
managed FSW (24 spread across 3 DCs in our case). Do you really have to
factory reset them all to get them up on...
We're doing an increasing number of SAML based vpn deployments and
windows + azure works well. However, other combinations we are
struggling with, for example. macOS + Google workspacewindows + Google
workspace varies, we see that both for mac and wi...
I'm posting this out of frustration at the complete lack of response
from Fortinet EMEA As part of this year's EMEA Xperts summit this
summer, participants were to receive a FG60F. We were sent a form to
fill out, which was done and returned in early...
Has anyone come across issues with using 40G QSFP DAC cables with, in
this case, Aruba CX 8325 switches (latest firmware release as of writing
this)? i've got an 1100E cluster (6.2.4) we're setting up for a project
and the HPE original DAC cables (JH...
Hi We have a basic 'active-active' set up with loadbalancers as per the
admin guide. Azure has one public IP. The onprem FG is a standard A-P ha
cluster.There will in the future be a requirement for further IPSec
tunnels to the azure side from other ...
Again, thanks for the response. Useful to know that it's a bug rather
than a missing feature. I'll go ahead and open a ticket as
suggested.Whilst we can work around pushing FSW port configurations via
cli script, it would be much more user friendly t...
Thanks for the response. Here's an example from my lab. config
switch-controller dynamic-port-policyedit "wifi"set fortilink
"fortilink"config policyedit "Aruba-AP"set hw-vendor "Aruba"set
vlan-policy "wifi"nextend and on the switchport edit "port4"s...
What is the best way of deploying a standardized switch model and L2
port/vlan configuration, but location specific L3 switch port
configuration? Switch module templates could work, but DPP as a mode is
not supported and i'm unsure if L3 vlan informa...
